Prediction Of Cutting Force In End Milling Of Inconel 718
This paper presents the effect of cutting parameters on the cutting force when machining Inconel 718. Response surface methodology (RSM) was used in the experiment, and a Box–Behnken design was employed to identify the cause and effect of the relationship between the four cutting parameters (cut...
保存先:
| 第一著者: | |
|---|---|
| フォーマット: | 論文 |
| 言語: | English |
| 出版事項: |
2014
|
| 主題: | |
| オンライン･アクセス: | http://eprints.unisza.edu.my/4955/1/FH02-FSTK-16-06862.pdf http://eprints.unisza.edu.my/4955/ |
| タグ: |
タグ追加
タグなし, このレコードへの初めてのタグを付けませんか!
|
| 要約: | This paper presents the effect of cutting parameters on the cutting force
when machining Inconel 718. Response surface methodology (RSM)
was used in the experiment, and a Box–Behnken design was employed to
identify the cause and effect of the relationship between the four cutting
parameters (cutting speed, feed rate, depth of cut and width of cut) and
cutting force. The ball-nose type of end mill with donwmill approach was
maitained througout the experiment. The forces were measured using
Kistler dynamometer during straight line machining strategy. The result
shows that the radial depth of cut was the dominating factor controlling
cutting force, it was followed by axial depth of cut and feed rate. The
prediction cutting force model was developed with the average error
between the predicted and actual cutting force was less than 3%. |
|---|